the piece in back behind the boom.
http://www.setecx.com/pics/cp102602const/imagepages/PICT0240.html
*** This post was edited by fred biscardi 10/27/2002 3:40:09 AM ***
1. Where is the track going to come from if it is connecting to the top connector of the tower on the left hand side. Will it come from the top, or support a turn from the magnum side of the midway into the break run.
2. They appear to be pouring footers close to the new web cam by ID - if so, what are they for.
3. Is it me - or are BOTH web cams now centered to the same place within CP, yet WAY off center of the current construction.
4. How much track is on site that contains negative G forces.
5. Why are they starting so early.
Tom
*** This post was edited by Tom 10/27/2002 9:15:00 AM ***
look at that piece again. it is not flanged on either side or the top thus it goes in place in the same position it currently sits, i believe. similiar supports here: http://www.rcdb.com/installationgallery87.htm?Picture=7
http://www.rcdb.com/installationgallery1635.htm?Picture=7
http://www.rcdb.com/installationgallery1574.htm?Picture=6
also
http://www.setecx.com/pics/cp102602const/imagepages/PICT0227.html
looking at other intamin ag coasters i think that piece could be the top of yet more verticle supports. :) hopefully!
Kevin Lehman said:
Fred, could you please explain how that piece can only go on another tower? To me, it looks like it could be on top of the current tower.
And if it did go on the current tower, it would mean there would have to be and inverted piece of track under that support. That support obviously caps some support off, so either the main tower is an inverted tophat (most likely not) or there's an inversion (most likely not) or there's another tower (most likely not), so where is this thing goin??? I completely agree with you Fred, it's just another tower seems unlikely to me. Great find though!!!
------------------
If the roller coaster scared you...
RIDE IT AGAIN!!!
I see that odd piece fred mentioned as one of the pieces that'd support the track on the drop side, provided that will turn 270.
Why is it so hard for people to believe those footers in a line will most likely be for tranfer track? Seems kinda obvious to me.
------------------
2002 Raptor Crew
"Hey, Cool. My voice is on the lift"
http://www.setecx.com/pics/cp102602const/imagepages/PICT0227.html
It is sitting upside down for storage sake. The rear and two side main supports will taper in to meet with this cap. The smaller post will be for a vertical brace. The flange off the bottom (top) will extend up to support the tophat. The flange on the side will suppot the start of the twistage down. What I am confused about would be the flange facing back towards the station. This doesn't seem like it would align with anything unless the upside of the hill comes over more towards the middle of the tower before hitting the tophat.
Any thought?
------------------
Wile E. Coyote. - Super Genius
*** This post was edited by Bob Densic 10/29/2002 3:54:50 PM ***
http://www.rcdb.com/installationgallery1574.htm?Picture=16
I don't think the triangular tower will have a support like that.
You must be logged in to post